Longacre 78282 No Sweep Digital C_C Gauge with AccuLevel (v Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Longacre 78282 No Sweep Digital C_C Gauge with AccuLevel (v. Longacre 78282 No Sweep Digital C_C Gauge with AccuLevel (version 3) User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 1
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
This gauge can only be used on large diameter tubular
spindles - both “Wide 5” and “5-on-5”.
An indexing adaptor is required to go inside the spindle (sold
separately - see adaptor instructions for installation).
1) Find a level place to set up your front end. This unit reads camber very accu-
rately. Unlevel ground will affect the accuracy.
IMPORTANT: BE SURE WHEELS ARE POINTED STRAIGHT AHEAD
WHEN SETTING CASTER AND CAMBER.
2) Attach the gauge to the spindle - the black gauge adaptor screws onto the
spindle snout. A narrow bar on the inside face of the gauge adaptor indexes with a
groove in the face of the spindle adaptor. Hand tighten the gauge adaptor.
3) To measure caster and camber slide the
AccuLevel™
into the groove of the gauge body as
shown below for each. Read the caster and camber directly (no need to turn the wheels to read
caster).
4) Adjust the caster and camber as needed. Each time you make a change bounce
on the front end to settle the suspension. NOTE: Adjusting the caster may have
an effect on the camber and vice versa. Double check all settings & tighten bolts.
See the separate instructions for the
AccuLevel™
on the
reverse of this if needed. It can be removed and used for other
measurments. Simply slide the
AccuLevel™
out of the
groove.
Monroe, Wa 360 453 2030 www.longacreracing.com
2/07
Ver 2 & 3
CAMBER
CASTER
Instructions For No. 78282
No-Sweep
®
Caster/Camber Gauge
Pat#7185438
Vue de la page 0
1

Résumé du contenu

Page 1 - No-Sweep

This gauge can only be used on large diameter tubularspindles - both “Wide 5” and “5-on-5”.An indexing adaptor is required to go inside the spindle (s

Commentaires sur ces manuels

Pas de commentaire